Review on OMOTON Tempered Glass Screen Protector for Surface Pro 7 Plus/7/6/5/4 - High Responsiveness, Scratch Resistance, and HD Clarity by Noah Lewis

I had this screen protector a week after receiving my 2018 Surface Pro. I love my SP 2018 so I bought this screen protector to protect my screen in case of scratches or accidental drops. This screen protector was easy to install because I've done a lot of things like this in the past, both wet installed and cured screen protectors. I know how to work in a totally clean place and no, I don't work in a bathroom where hot water runs in the shower to let the steam get rid of the fluff in the air. I think a bunch of bs. If you clean the screen well enough, there will be no bubbles or lint under the screen protector, making the device look cheap and dirty. I don't know how people can stand a few bubbles on their device and use it with clearly existing bubbles that they can remove with tape. When installing, I would advise you to take a few small length pieces. The tape is done so if there is a bubble you can get the lint underneath and remove the bubble. No bubbles go away over time, and if anyone tells you that, they're lying to you. Bubbles are 99.9% dirt or lint that gets caught under screen protectors, especially tempered glass screen protectors, and there's no way to remove this bubble unless you use duct tape to remove the lint. I would start by lining the screen protector. into the ideal position and use a couple of pieces of tape and form a loop at the bottom of the protective sheet. Give it some room as you'll need to pull it out again and remove the protective film underneath from the actual screen protector and make sure everything is lined up the way you want, then carefully lay it down on a flat surface. and place your thumb in the center and move to the edges to remove any bubbles you can. If you have bubbles, pay attention to where they are and gently and slowly peel off the backing so the lint is underneath, then reattach. There is no easy way to install such a tempered glass screen protector other than the one I have described. It is difficult to put a protective film on such a large device. After I installed mine I had a tiny tiny bubble that I taped to reach and pull out. In my case, I suspect a defect in the screen protector in this area, but it is so small that I don't even notice it after a day of use. Please be careful when removing the protective film as you may break the protective film or fold up the edges and they will never sit and you will only have a big gap in the corner where you removed the protective film. a way. When all is said and done, remove the remaining tape that forms the judge for you and you are good to go. So far I haven't had any issues with the screen protector and have been using it for over 6 months now. I would recommend this tempered screen protector to anyone looking for one because it's cheap and it works. You just can't beat it! Let me know if you have any questions at dareviewer81@gmail.com.