Review on Pack Of 3 HICTOP 3D Printer Brass Nozzles With 0.4Mm Diameter And 1.75Mm Extruder Tubes For Reprap Prusa I3 by Mark Repp

I have a Monoprice Mini and my head got jammed. I think I damaged it trying to repair it, so I went looking for replacements. The only differences between this and the monoprice head are that the tip is a bit longer and the section on the Monoprice that goes into the heatsink is unthreaded. To make sure the contact with the heatsink was good I used thermal compound to fill the threaded areas. This resulted in some slipage, so I had to make sure the screw that held it in was extra tight. But with that fixed it worked great.