Review on PSCCO Bulkhead Barbed Fitting Connector by Drew Gengler
Will not fit hose with ¼ " ID
These barbs are good quality but not for ¼" ID hose. They are too small. The spike penetrates the hose with no friction. The barb should take some force to slide into the hose. It looks like this looks like they are actually made for 6mm ID metric tubing, which is probably the standard in China. Don't expect a tight seal with them. I've attached photos comparing one of these devices to a real ¼" Show ID hose tail.
- 商标主人QQ510637638 -- Connector has 2 barbed ends that provide a secure fit on hose when used with a clamp, ferrule or ferrule (not included).
- Cord is shorter than other
New products
Comments (0)
Top products in 🔧 Fittings
Vacuum cleaner Dreame V9 Global, white
145 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
