Review on G8P 1A4P 12VDC Hermetically Sealed Relay for Panel Mounting, 250VAC by Sam Lund

only. This is an OEM replacement for the Dryer Motor Control Board Relay. In fact, in most cases the relay does not fail, the track around one of the relay contacts simply breaks. Sometimes the contact burns out so badly that it is very difficult to solder it, and it's easier to just replace the relay to avoid bad soldering during repairs. With the rail broken you need to make a small loop on the wire to put it over the pin and solder the pin, wire and rail back together. The wire should continue in a good way to the other two pins on the board and solder to the pins in a continuous connection. then do the same for the good side or it will explode next. These reinforced jumpers prevent future problems.