Review on 🔧 Cabinet Hardware Jig Tool: Drill Guide for Cabinet Handles and Knobs – Template Tool with Storage, Perfect Power Tool Accessory for Easy Installation of Handles and Pulls by Darrin Lucas

I am renovating my kitchen and have 66 European staffs to install new cabinets. We just remodeled our laundry room and installed poles in the same style and it took forever to line up and drill. We had a hard time getting the holes etc. together. With that in mind, I found this on Revain and decided to give it a try. There are no instructions in the kit but as someone mentioned you can find out after watching the video. It consists of two metal parts with embossed dimensions. If you look at the picture I've attached you can see how they fit together. The top plastic piece is at the top of the vertical clearance drawer. There is a slide stop on the horizontal piece of metal that can be placed on the left or right side of the front of the door. So between two parts, vertical and horizontal, you can achieve the same space over time. The other two slide stops are for drilling holes. Since I had tie rods and no handles, I had to drill 2 holes per handle. There was a lot of sliding in the device because you applied pressure to keep it in place. So keep an eye on that slight movement and you'll be fine. That was redemption. It took me about the same amount of time to make 66 pens in 4 different sizes as it did to make 12 pens in a laundry without this machine. I highly recommend it.