
I needed to replace my sailboat’s cockpit drain tubes and this 1.25” ID tubing was exactly what I needed. Other tubing was much too stiff (even when heated in hot water) to be pliable enough to connect a PVC pipe to a thru-hull connector, since there were only a few inches between them. Add a few hose clamps and no more water will be getting inside my boat. (Well from here anyway!)

1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review

Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review

High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review

DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review