Review on Furiga Printer 50X50X15Mm Blower Cooling by Michael Cleveland
A fan is broken: Computer components
After running these fans for a few days, one of them started making an awful noise. Upon further investigation, it was found that there were parts inside the engine. I don't know what happened there. On my Ender 3 printer, the plus and minus do not match the polarity of the fan cable. I had to switch red wire to black wire and black wire to red for it to work. The length of the cable wasn't long enough for my Ender 3 either. In general, I would not recommend these fans.
- 24V DC 3D printer 50 mm fan Radial fan
- The list is long.
New products
Comments (0)
Top products in 🧰 Computer Internal Components
Another interesting products
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review