Review on 💨 Enhanced Performance: The Standard Motors RU440 Blower Motor Resistor for Efficient Climate Control by Richard Koh

Installed on a 2010 Ford Escape when the fan stopped running on speed 1 and speed 2 but was still running on speed 3 and 4. The installation was the wind. Push on the sides of the glove box to fold it in, remove the exposed wiring harness connector from the top of the resistor, use an 8mm socket to remove the two screws holding the old resistor in place, replace these and reverse the process. To install. It took less than 20 minutes from start to finish. The fan will now run at speeds 1, 2, 3 and 4. The benefit of this particular part is that the holes on the top of the resistor mounting plate are pre-drilled in the correct location. From what I've seen online, some other brands require holes to be drilled. Not a big deal, but it makes things a lot easier. Would buy again!