Review on 🔧 Premium Phenolic Zero Clearance Insert: Compatible with Delta Uni-Saw Contractor, Large Grizzly, and Other Table Saws - 13-3/8” x 3-3/4” x 1/2” Throat Plate Opening by David Jones

Purchased for a Dewalt 10 inch table saw. Got it today when I was trying to install it, WAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA is too tight to the point you have to hammer it in with a hammer but np. Sanded about 3 times with 240 on one side to get a good fit. Then when I actually managed to fit in properly. thought it was 3/16 to 1/4 inch too thick. and also from 3/8 to half to a small length. ABSOLUTELY UNBELIEVABLE. If this is for Dewalt, DO NOT BUY IT. Had to rip it off to make it sit flush and then on EVERYTHING, pilot holes to line up flush with the top. All adjustment screws were out of place! So I had to drill new pilot holes, then take new screws and cut them off. Also had to buy a new longer screw for the length adjustment screw as it was too small for the 3/8t spacing.