Note that your fan should have two screw holes on each corner, not one long screw hole. Usually you insert the long end into the screw hole, then grab the end and pull. As it stretches, the bump disappears. Do this with all four corners, then place the jar where you want it and pull the thicker short pieces through the body. The rubber rims form a good vibration barrier, and the whole thing acts like a rubber screw for extra dampening. Vibration.
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review
ZOTAC ZBOX-CI325NANO-U Series Nano Fan-Less Mini PC Intel N3160 Quad-Core CPU Silent Performance Barebone System SSD & RAM Not Included, No OS
12 Review
DSD TECH 2 PCS IIC OLED Display 0.91 Inch: Perfect Arduino ARM Accessory
9 Review
Neural Compute Stick 2 by Intel
12 Review