Review on 📷 Logitech C310 High-Definition Webcam by Ada Kuakowska ᠌

Name: 📷 Logitech C310 High-Definition Webcam
Item: 📷 Logitech C310 High-Definition Webcam
Rating: 4

March 03, 2023

Good value for money, I recommend it.

In most cases, I'll go with a brand-new model. The likelihood is that I will purchase either the C270 (because, according to the feedback, there is hardly any discernible difference between the two) or the 310 once more, but I will preserve the receipt.
In all other respects, the camera is serviceable. But, the length of the chord may be longer. I brought along a longer extension cord.
The opaque green light that indicates there is work to be done (does not blind).
The frame rate does not decrease when it is dark.
There are some fundamental software configurations available there. There was a period when even that location underwent a transformation. Adapted)) Watched the stream with her. The Chrome key catches in the usual manner. In what other areas do you have an interest?
Spend without fear, then put the receipt to good use.

Pros

The ratio of cost to value. Although I despise seeing this statement in evaluations, it is accurate. 2300 in the year 2022 is equal to one month of taking the bus to work. Also, the picture is of a crystal-clear quality at 720p (even with small scale reductions with a "ladder").

Cons

Therefore, she was employed for around 18 months. Broke. This is the reason why: If the camera is not unplugged from the computer, it will continue to operate normally and will not become as overheated as it otherwise would (I will try not to allow this to happen again). One day, however, I was given stripes rather than an image. I pressed it twice, and the image appeared on the screen for a total of three seconds. I began to disassemble it. There is nothing unusual about the board itself, but all of a sudden, a picture appears on it when it is bent ever so little. It is very evident that the contact was severed in some location by using solder. The region surrounding the camera is the one that warms up the most as a result of this. You should press the camera area. BINGO! In most cases, there will be a crystal that will need to be soldered onto the board. This crystal will require either a hair dryer or a micro soldering iron in order to be soldered. I don't have such equipment. Take it someplace - don't be silly. Companies that specialize in caricature assembly are unable to provide unambiguous assurances and do not know how to fix micro-equipment. Bent, bent despite having been earned, fixed, and collected; it still doesn't work and is in a bent state. earned didn't work fixed earned again didn't work bent earned again didn't work ...and she never demonstrated it again)) In point of fact. It was worth just leaving it devoid of a body and bending it at regular intervals))) It would be sufficient for an additional four streams!