Review on Enhance Your Engine's Performance with Federal Parts 3116 Spark Plug Wire Set by Logan Goozmer

Purchased for a 1995 GMC Suburban C2500 with Bosch 4207 (x8) spark plugs and ACCEL 8132 Billetec Performance distributor cap and rotor. The entire project took 2 hours and only required tools: 8mm socket for disconnecting the battery, Phillips screwdriver, wire marker, spark plug protector and 3/8" socket wrench with 3" and 6" extensions and flexible 5 /8 inch key. spark plug connector. First disconnect the battery cables with the 8mm jack. Loosen and remove the air cleaner wing nuts (x2) and remove the components (cap, filter and assembly) ONE BY ONE, remove the OLD wire from each spark plug, mark the caps on both ends and stems of the OLD distributor cap with the corresponding location number with marking. Remove the SHORTEST center wire from the distributor cap. Mark the NEW distributor cap bolts with the correct OLD distributor cap bolt position number. Match the NEW wires to the length of the OLD wires, then mark the caps on each end of the NEW wires with the corresponding OLD wire position numbers. Using a 3/8" socket wrench and a 5/8" flexible spark plug wrench, remove each spark plug. Spark plugs 3 and 4 require a 6" extension, the rest require a 3" extension. Adjust the gap (0.035 inch) of NEW gapped spark plugs and open or close as needed. Hand tighten the NEW spark plugs, then tighten with a socket wrench. Loosen the OLD distributor cap screws (2pcs) with a Phillips head screwdriver, then remove 2pcs) with a Phillips head screwdriver. tighten or you may uselessly damage the cap. Install the NEW wires to the appropriate locations of the spark plug on the engine and distributor cap. Install the NEW center cable. Reinstall the air filter components. Connect the battery cables.