Review on Computer chair Metta Samurai S-3.04 for executive, upholstery: textile, color: gray by Adam Trela ᠌

Replaced my old Samurai S-1 chair after 4 years of use. Actually, the only drawback of that chair was a creak that appeared in the second year, but the creak was corrected by the first treatment of everything under the seat with a silicone spray. And even with the first chair, I ran into a gas lift marriage, broke down in the first month, changed it to a new one, which works like that. Reason for replacing s-1 with s-3.04: 1. Adjustable armrests - the old one had ordinary ones and they prevented you from driving (or removing the chair) under the table and limited the height of the chair relative to the table - you can’t go higher / lower, because the elbows / hands will hang; 2. Normal headrest - the s-1 has one name - an absolutely useless gasket between the back and head; 3. Adjustment of the lumbar support in height and FINALLY normal fastening, on the s-1, the side screws holding the belts under the lower back were periodically unscrewed and these belts flew off, I had to re-fasten everything. Assembly is even simpler - no implicit moments, which were during the assembly of s-1. Impressions: as a person who has been using a similar chair for the last 4 years, he is completely satisfied - comfortable features in the new one have been added to the comfort of the old chair. Everyone is happy. Before buying, purely out of academic interest, I read the reviews. Most of the problems described are either an obvious marriage, or the curvature of the authors. On s-1, the same as not a comment, then something falls off, bursts, explodes - all this is explained in a banal way - they didn’t tighten it properly, or they didn’t consider it necessary to use a washer. I am sure that the only jamb of the new chair will be the same as the old one - it will creak sooner or later (creaked), June 2022 The creak cannot be eliminated with grease - the frame itself creaks. Time to look for a replacement.