💧 Enhance Water Quality with 3M Aqua Pure Whole Filtration Housings Filtration Review

Looks like a quality product, installed two in line and hasn't affected the water pressure in any way! I definitely no longer notice the chlorine smell in my water! Installed for a month and no leaks!

Installed by a plumber and have been using for about a year. should last 20 more. I'm thinking of buying another one so I have a second stage for the Fe/Mg filter. I need to get my plumber back!

We have a well with very orange colored water. We had a large water filtration and neutralization system that never worked properly so we replaced it with this one. Takes up little space and cleans the water very well. Due to our water conditions, we have to change the filter about once a month. It only takes about 10 minutes and the filters cost about $25. Great buy compared to other expensive systems.

Installation has just been completed so this is not a long term review. Make sure you buy o-ring lube as it is not included and you need it to seat properly and not leak. So I'm going to take off a star right away because o-ring lube isn't that easy to find! The instructions don't even say you need it. When I was trying to find the right lubricant, one 3M technician told me the o-ring was butyl rubber and another said it was nitrile. So use Super Lube 92003 Silicone Grease as it is compatible…

I would give it more stars if the system came with the mount; Instead, you have to pay an additional $19 ($7.79 shipping and handling fees) to have the braces part of the system. Likewise; a small tube of grease for the canister and o-ring threads. It's almost impossible to install without it as the canister will get stuck before the threads are fully tightened causing leaks and the o-ring will snap if you try to tighten it properly or break if you try to unscrew him. It would be nice if they…

This is a high filter. I read the reviews. This is the one I wanted. I received the mount they sell separately. It is worth buying. Do not be shy. Inlet and outlet 1 inch. I read a review that said there wasn't enough thread for a good seal. For real? I thought everything was fine. Of course you want to use teflon tape or plumber for the threads. Do it, twist it hard and you won't have any leaks. leaks. I had a drip for about a week. The LARGE o-ring on top needs to be turned quite hard to get…

This filter was difficult from day one - poor design. It installed fine, but each filter change was a real pain. First you have to rip the filter housing off the base. Always difficult, although I've cleaned everything thoroughly and applied sanitary silicone to the threads and o-ring with every new filter. It was also a challenge to fully assemble/seal the filter housing with no leaks. It was finally time to replace it again today and the filter housing was completely stuck to the base. I…

We've been using the Brita jug for years, but we knew we needed a whole house filter for three main reasons: (1) always because of the faucet and without waiting for the Brita to fill up, (2) remove chlorine from shower and bath water and (3) remove sediment and "dirt” from our water. Ultimately, it was point 3 that pushed us over the edge when city water kept clogging your kitchen faucet and it was too tiring to go back under the sink and fix the faucet. We knew we didn't need a water…

Aqua Pure AP 802-1" 45 GPM Water Treatment System 23/2014. I wrote this review because in In In the past I have always checked the reviews when purchasing an item on Revain and found that they helped me with my purchase decision June 30, 2014 I left a review Again the only brief benefit of the filter is that the cap protects the filter does not have built in "brass thread inserts" (the threads are flat) as there will be a gap between the threads as they are made of different material and…