🔥 ARTR 4PCS 50W 6ohm Load Resistors: Fix LED Bulb Hyper Flash & Error Code-Handle Overheating Review

I bought these resistors to try and solve a hyper flash problem when trying to LED my 2014 ram -Convert turn signals. They arrived neatly packaged and (always with Revain) on time. As an electronics engineer I tested them and they actually showed 5 ohms. I installed them correctly but was very disappointed to see that my problem was NOT solved. While I'm sure these resistors are a key element in converting to LEDs in my particular truck, I must continue to look for what else in the truck is…

If older vehicles are retrofitted to use LEDs in turn signals, these terminators MUST HAVE! The flashers in most older vehicles are of the HEAT LOAD DEPENDENT type. This means they have to "see" the specific consumption of the amp to make the turn signal "blink slowly" like the factory bulbs did. LEDs use significantly less power and don't allow the turn signal to "warm up" enough to flash at a slower constant rate, hence the "hyper flashing" you get without the pull-up resistor. On some older…

My first impression of these resistors is that they are well made and of good quality. The supplied T-connectors are of standard basic quality and can be found in every cargo port. The resistance wires are very well insulated and must be very strong. The heatsink around the resistor makes it impossible to see the resistor itself. This heatsink appears to be solid aluminum and has well-spaced cooling fins on all but one side. I estimate that about 75% of the resistance have radiating fins. 2…