Header banner
Revain logoHome Page
🔧 2-pack of 4shank×2 grinded machine slotting bits logo

🔧 2-Pack of 4SHANK×2 Grinded Machine Slotting Bits Review

4

·

Average

Revainrating 3.5 out of 5  
Rating 
3.5
🔧 Milling Accessories, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(2)
img 1 attached to 🔧 2-Pack of 4SHANK×2 Grinded Machine Slotting Bits
img 2 attached to 🔧 2-Pack of 4SHANK×2 Grinded Machine Slotting Bits

Description of 🔧 2-Pack of 4SHANK×2 Grinded Machine Slotting Bits

4 Flute,Cutting diameter=1/4'',Shank diameter=1/4'',Flutes length=3/4'',Overall Length=2-1/2''. Material:M2AI,High Speed Steel,long tool life. Suitable for aluminium,cast iron,copper,magnesium alioy,plastics,wood etc(under HRC32(HRA66)). Full grinded,4 Flute,high abrasion resistance,obtain accuracy and fine finish. Package:1pc×end mill cutter.

Reviews

Global ratings 4
  • 5
    1
  • 4
    0
  • 3
    3
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

True 1/4 inch is 0.250 inch.

These are good end mills at a bargain price but they were of little use in my application but I am not returning them, they are mine!

Pros
  • Square Nose
Cons
  • I will add later

Revainrating 3 out of 5

A little more chatter, but still good quality

This is definitely an expensive alternative but less rigid than others I've bought. I need less vibration, but despite lots of feed, speed and depth of cut adjustments, I couldn't get rid of the vibration marks.

Pros
  • Material: M2AI, high-speed steel, long service life.
Cons
  • unreliable

Revainrating 5 out of 5

Easy Milling Stainless Steel

I used it to mill 38° holes in ½" and ⅜" steel. Drilled a total of 40 holes with no problems. After that, I was just curious to see how it would work with stainless steel, so I drilled a hole right through the ⅜ inch stainless steel with no chipping or drill breakage. Of course I used Kool Mist coolant. sharp and chip free Needless to say I am very impressed with this racquet and did not expect such quality for the price.

Pros
  • 4 Teeth, Edge Diameter = 1/4", Shank Diameter = 1/4", Tooth Length = 3/4", Overall Length = 2-1/2".
Cons
  • Small parts

Revainrating 3 out of 5

So-so end mill: Milling accessories

I thought it would be a good idea to get a Wokesi 1/4" x 3-1/16" end mill to get my 80% down instead of the expensive 4" end mill which is on sale with my template.My plan was to use this shorter and cheaper end mill for most of my routing work and then switch to a 4" end mill to finish the job.. But after only one cut this end mill dulled so visibly that when I was milling the second receiver the milling became noticeably slower and rougher and I ended up spending more time on each pass.While…

Pros
  • Packing: 1 pc. × End Mill
Cons
  • Crumpled Packaging