Header banner
Revain logoHome Page
abn pneumatic standard bearing 3 piece logo

ABN Pneumatic Standard Bearing 3 Piece Review

2

·

Excellent

Revainrating 5 out of 5  
Rating 
5.0
👊 Pullers, 🔧 Automotive Tools & Equipment

View on AmazonView on ЯM

Media

(4)
img 1 attached to ABN Pneumatic Standard Bearing 3 Piece
img 2 attached to ABN Pneumatic Standard Bearing 3 Piece
img 3 attached to ABN Pneumatic Standard Bearing 3 Piece
img 4 attached to ABN Pneumatic Standard Bearing 3 Piece

Description of ABN Pneumatic Standard Bearing 3 Piece

EFFORTLESSLY REMOVE BEARINGS: Use the ABN Pneumatic SAE Standard Rear Axle Bearing Puller 3-Piece Service Set – Domestic Car Vehicle Bearings Removal Tool Kit to service semi-floating rear axle bearings on your vehicle; These tools make the job simple and prevent damage to your bearings when pulling; Much easier than claw-type axle bearing pullers that slip off and chew up the old bearings; For removal only, not intended for installation. EASY TO USE: Slide flat end of puller through center of bearing and flat against backside of bearing, then slide washer down the center of the shaft against front side of bearing and tighten the nut on smaller end of puller, then thread a slide hammer (not included) to the puller and slide hammer back and forth until the bearing comes out; The washer captures the bearing firmly to distribute the applied force over the entire bearing and prevent damage. FITS YOUR CAR: Standard SAE sizes work for most American domestic makes and models; Set includes the following sizes to fit main bearing tube – 1 inch to 1-7/8 inches, 1-5/16 inches to 2-3/8 inches, and 1-3/8 inches to 2-7/8 inches; Sizes permanently laser-etched on tool for easy identification; Each tool fits a basic slide hammer with a 5/8-inch x 18 thread pitch. EASY STORAGE: Heavy-duty plastic blow-molded carrying case for easy transportation, safe storage, and quick organization. PACKAGE CONTENTS: Package includes (3) rear axle bearing removers and (1) carrying case for your convenience; Slide hammer not included.

Reviews

Global ratings 2
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Works like magic - my new review

Based on our own experience, this pneumatic standard bearing puller is a lifesaver. It makes removing any stubborn bearing or pulley a breeze .The three-piece design is sturdy and durable, and the pneumatic power adds an extra layer of convenience. However it's a bit expensive compared to other manual options on the market..

Pros
  • Efficient, reliable and easy to install
Cons
  • Requires a pneumatic system to function, limiting its use in certain situations

Revainrating 5 out of 5

Great tool for your money.

Great tool! Slightly too big for the rear axle of a 92-99 Gm truck. I had to sharpen the big ends a bit. The bearing housing broke on the smaller size, but I didn't remove it! Overall I saved $500 by making it myself. 👍

Pros
  • PACKAGE CONTENTS: Includes (3) rear axle bearing pullers and (1) carrying case for your convenience; Slide hammer not included
Cons
  • So far so good