Header banner
Revain logoHome Page
🔧 accusize tools indexable additional cutter 0028 8308 logo

🔧 Accusize Tools Indexable Additional Cutter 0028 8308 Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.7
🔧 Milling Accessories, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(3)
img 1 attached to 🔧 Accusize Tools Indexable Additional Cutter 0028 8308
img 2 attached to 🔧 Accusize Tools Indexable Additional Cutter 0028 8308
img 3 attached to 🔧 Accusize Tools Indexable Additional Cutter 0028 8308

Description of 🔧 Accusize Tools Indexable Additional Cutter 0028 8308

3/8", 1/2", & 5/8", 90Degree Cutting angle. Nickel Plated. Screw down insert. Radial rake angle: -10Degree. Axial rake angle: +7Degree. All types of square shoulder face milling, side milling and full slot milling (shaft end mills) of steels, alloyed steels, stainless and heat resistant steels, cast irons and aluminum alloys. Fitted with 10Degree positive rectangular insert allow high depth of cut and feed per tooth. with 8 ps additional screws + 1 Torx Wrench. Uses APKT / APHW / APKR_APht / APMT insert (sold separately).

Reviews

Global ratings 3
  • 5
    2
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Worth the money

Good mileage. Cuts steel well with some lubricant. The original carbide bits didn't last long, but the upgraded ones work well. Cut a half inch groove with a half inch bit, came out 5 tenths more than enough for me.

Pros
  • Cutting tools
Cons
  • Damaged

Revainrating 4 out of 5

The price is right.

end mills work with no visible problems. They give a good finish on mild steel but I don't know what they do with stainless or high carbon steel. If the carbide chips or becomes dull, a good quality carbide can be used as a replacement.

Pros
  • side cutters
Cons
  • I don't remember but there was something

Revainrating 5 out of 5

Nice little set, great backup or main for end mills

If you're buying a set of two and four flutes for $89/pack and they wear out, buy them as a set. Good for small diameter scrapers. Insoles are good. Buy aluminum inserts for non-ferrous metals.

Pros
  • Industrial & Scientific
Cons
  • Long Lead Time