AccusizeTools Indexable Carbide Turning 2387 🔧 2004: Precision Machining Solution for Turning Operations Review

Excellent cutter set. They all seem to have some sort of rust remover that should be scraped off completely. When used without cleaning, the heat from metalworking captures the small screw that holds the carbide insert in the holder. This makes it almost impossible to remove to swap out the insert. Once that's done, you won't be able to find better tools than these.

Looks good quality. My first filming with the kit cut clean and neat. The matching cardboard liner appeared glued upside down as all the tools were placed cutters down where they couldn't be seen. overall still a good buy. If desired, it would be possible to add a full complementing set of inserts, allowing me to keep a free hand for each instrument.

I have an old Harbor Freight 14.5 inch mill/hand lathe. Additional tool holders are available at a great price so you can have one for each bit and line them up perfectly. Very well made and the bits are finely ground. I used a simple steel ruler to level and it worked great. I made a cut on some small diameter brass rods. I will also use them on aluminum and steel. A bit of thread is included in the kit and I don't need it. I suggest including a boring bar for us manual lathe owners (more…