💡 Efficient AIMS Power 1250 Watt / 2500 Watt Peak DC to AC Inverter - Economical Solution for Power Conversion Review

Inverter did not turn on at 32°F (green LED on). Works fine at 45 degrees Fahrenheit but cuts out at 11.8V due to low voltage, the spec says 10V +/- 0.5V. Probably a good inverter if running at high temperatures.

Installed this on my 400Ah 12v batteries and then used it with a 4-1/2" Milwaulkee angle grinder to cut some holes in a steel building. in a minute. The starting current of the motor usually causes problems with inverters, not this one love the product I would buy it again The current draw in stand-by mode is very low.

I bought two of these, the first one works very well, the fan stays on all the time, very powerful. The second is a newer model, it's not the one in the picture, it seems much lighter, not as heavy as the first, but it works about the same, and the fan should be a heatsink, it turns on and off Buy it even if the device is needed. This is a plus. It consumes less amplifier to drive the inverter. I just hope it lasts until you buy the first one as there is nothing wrong with the first one. I only

I bought this inverter to power an electric water pump to fill barrels for cattle in the field. It drives a 1hp water pump that draws 800 watts and gets the job done perfectly. Never before has it been possible to pump water so quickly with dispensers that are twice as expensive and prone to failure. I can think of many applications this inverter could handle including powering a portable band saw to cut pipe without having to carry a heavy generator to the job site. A car battery and inverter…

I have been using this inverter for 2 years and 10 months. At this point, the inverter suddenly stopped working. A table fan was connected to it. The fan ran, then stopped because the AC voltage disappeared and never came back. There are fuses in there. I opened the case with a screwdriver and tested it, but none burned out. When running, the inverter would get stuck in shutdown mode unless the 12V power supply was turned on cleanly with no glitches. Turning on the engine ignition to start…