🔌 AIMS Power PWRIX120012SUL Pure Sine Inverter with Transfer Switch, 1200W Continuous Power and 2400W Surge Peak Power, Intelligent Cooling Fan, Transfer Time Less Than 20msec Review

Works as described. A question not answered in the manual is whether the chassis GND should be connected separately or whether two GND cables will suffice. It appears that the electrical ground and case are tunnelled.

Used in vans for fridge operation only. Ease of installation. Tested briefly. Nothing long term so far. He replaced a broken 1000W WFCO WF-5110HP. The old one had a digital display, the new one just indicator lights. The new one is cumbersome.

Works great as a good inverter. I had an Eaton Bussmann in my last truck, but I bought this one because it was $150 cheaper. The only thing I don't like is the small power button and the fan also works without a load on the device. So if your truck is parked and unplugged when hot it will slowly drain your battery.

This inverter has all the features I was looking for but runs for a few minutes then goes into failure mode and stops working. It's too late to return it, so $286 wasted. I've ruled out under/over battery issues and it's not overloaded. In fact, sometimes it runs for up to ten minutes, and then for no apparent reason, a high-pitched warning beep sounds and the error light comes on.

I bought one of these, it was about 2 years old and it blew. It was as if he smelled it. then i bought another one thinking maybe i could get 5-10 yrs but that just happened last week. Remove the cover and check if the internal fuses are blown. Hopefully . This one is 18 months old. I think I'll have to look for another brand. Updated 07/25/2021. I've just opened up the inverter and found that 4 x 40 amp fuses have blown, just replaced them and we'll see if it works. See you soon 😎 **Update…

This is a great inverter. The soft start function is both an advantage and a disadvantage. For some things, a soft start works great as the power can be increased until the device is running at full speed. I was able to power a couple of pro saws and he even tried and slowly started a 10" miter saw until it went to full power, exceeding its rating, and kicked it out. I tried it on a 6" joint that just wouldn't start. I tried a cheaper chinese 1500w brand (not sure of brand) without soft start…