🚚 AKD Part 2pcs 84W LED Pods - 5 inch Spot Beam Philips LED Light Bar Work Light Driving Lights - Super Bright Off Road Fog Lights for Truck Bumper Boat Review

Couldn't be happier with these headlights, great looks and they are very bright I put them on an 01 Silverado as the reversing lights just hook up the wiring to the light wiring, reverse and hole cut, and it's pretty easy to install

Exactly as described and easy to install. Both of my original lights went out and I wrote to the company. They walked me through a few steps and it didn't work so they sent me a brand new set. Very fast response time and very good communication. Affordable lamps that look good and great customer service. A+

I am very satisfied with these lamps and the customer service. I had a broken lamp from the two that arrived. I sent an AKD message and received a full new set of bulbs at no extra charge and they arrived much quicker than I thought which will hopefully work when I swap out the bad light for a new one!

Longer LED bar from Walmart. I bought the second one from Amazon. This Amazon lightbar is poorly designed, cheap and not worth putting on my truck. I read the reviews on this product, which quickly got me concerned. I think it will be a headache in the future. They're light and I wouldn't put my faith in them being waterproof. Don't waste money. over!

Installation went as expected but light output is lower than I expected. And even more disappointing is that the light is not very white. It is white in the center but surrounded by a yellow ring. Presumably it should be 6k like my LED headlights and 24" light bar. Their colors are the same, while for comparison it's almost an old school halogen color. I'm considering exchanging them or just returning them.

First I did a little research and testing to make sure I had the right cable to connect to my truck. Finally I worked up the courage to cut holes in the rear bumper and installed it. They look great and work! Very light. I've seen other reviews complain about the moisture wicking inside but I haven't had any issues so far. I even pressure washed my truck (NOT sprayed directly on the headlights) and no problem.

My RV's factory headlights are iffy at best, even after refocusing. My RV model does not have factory headlights. (2013 Winnebago) I placed them in front and turned them on after turning on the factory headlight and full streetlights. They mount flush but after focusing they may not be flush due to the kinking of the front clip but there is a little black window grommet and sealant and they look nice without shrinking from the camper.

Lighting works. With this in mind, the listing of this product shows that the light shines over a much larger area. When mine light up they look more like two headlights covering an area about 5 feet back. Installation was a nightmare. The "template" you receive is not the correct size. After tracing it into my bumper and cutting a hole, I spent the next hour shaving the edges until it finally fit. Also note if your bumper is not perfectly flat. There will be a gap even if the light is pulled…

I fitted them to an aftermarket rear bumper on a 2015 Jeep JK, they look good, factory like and I'm happy with the look. Brightness just isn't bad but good value for money. I like the flush mount, but installation difficulties can vary wildly depending on where you place it and what material you have to cut through to drill the required holes. I traced the supplied template on my bumper and then used a plasma cutter to manually cut the required holes in the 1/4" thick steel, which isn't easy…