🔌 Alla Lighting 2pcs 50W 6ohm Load Resistors - Eliminate LED Turn Signal Bulb Hyper Flash Error Code & Malfunction, Ensuring Fast Blinking Fix Review

The product conforms to that declared. The installation went without any problems and after the installation I had no more hyperflash problems. I will continue to work with Alla Lighting.

I like the size of the resistors and the mounting is easy. I'd like to be able to use a resistor for two bulbs that are close together in my taillights.

They do what they're supposed to do, resisting to make my turn signals work properly, but they seem to get very hot - too hot to tie down. They melted the zip ties and carpet next to the turn signal terminals. Use with caution.

Works great. If you are initially buying headlights and they say you may need them, save time and buy them with your headlights. They are inexpensive and fix your hyperfirmware and computer code. After setting your alarm, let your alarm blink for 20 or 30 seconds. It becomes hyperflare at first, but straightens up after a few seconds, at least that's how it went for me and since then it's been perfect and without problems 👍

I bought these to replace the LEDs on my vintage truck but then found some turn signal modules that would be easier to install. But I also work with electronics and they are perfect as dummy loads to service amps. So I left her. They look like good solid resistors and I wouldn't hesitate to use them for their intended purpose. A clip on the wiring makes connecting easy, but finding a position and drilling can be tricky depending on the vehicle.