💡 Alla Lighting 3800lm 2504 PSX24W LED Fog Light Bulbs 12276, 6000K Xenon White Xtreme Super Bright PG20/7 Base ETI-56 SMD 12V Upgrade - Ultimate Fog Light Upgrade for Enhanced Visibility and Safety Review

You can simply see the difference! The picture doesn't even show the full product, you can actually see the difference in person! A pretty reasonable price for such a quick and easy upgrade! I highly recommend! The picture shows the original fog light on the left and the product fog light on the right (sorry for the puppy tail).

These are great but if you are buying them for a Jeep please do your research. You'll also need a 50 ohm resistor to make the car think you've replaced the bulbs with regular ones. We put them on without them and they flash on and off. I hope the resistor solves the problem.

Installation was pretty easy after I jacked up the van. The factory clamps are brittle, so I accidentally broke one side. The replacement bulbs seem to last longer than the originals. Instant brightness change. Much better visibility and they look much better. I can't wait to find a kit for my headlights that is also ready to go.

Turn them on on Sunday, they are very bright and have good dispersion, so you can see the left and right side of the road better. I drive a lot on country roads and deer are everywhere. Now I can even see them without turning on the high beams. I think I need to change my headlights now. Do you also make headlight replacement kit for 2016 Jeep Patriot?

They're bright, I'll give you that, but they're vertically polarized, not horizontally. Traditional fog lights have a single point of illumination, i.e. the filament, and focus this light through reflectors to create a wide horizontal beam, left to right, narrow vertically, up and down to cut through the fog illuminating the road. If they were rotated 90 degrees that would be great. It would be horizontal. As they are now, they cast a lot of light everywhere just not where they should. I pulled

Although they say they work for my 2010 Avenger, they don't. They were difficult to install and flickered after installation. Sometimes one after the other, sometimes both, sometimes a life-threatening situation again and again when searchlights are needed. I actually got pulled over because they kept going on and off when I was behind a cop. After researching via google and youtube, this turned out to be a common problem with LED bulbs that required installing a resistor to support and use…

Bought these to replace the stock/OEM fog lights on my Subaru BRZ Ltd. 2013 Both bulbs burned out within five days (after 93+k miles). I've never been a fan of the stock bulbs as the color didn't match the xenon headlights and they weren't particularly bright either. These new LED bulbs lived up to the hype: significantly brighter than conventional bulbs and easy to install (insert and close). play). For me the hardest part of the upgrade was removing the old lightbulbs. Seven and a half years…