Amana CNC Spoilboard Surfacing Rabbeting Flycutter Tools Review

I paid a lot of money for this Carbide Blade Attachment and two of them broke! This is of course rather disappointing. I will leave a full review until I see how the support team is handling this.

I run a workshop making bespoke wood products and over the last year this piece has become an incredible asset. Accuracy is dead. Also, replacement carbide bits are readily available and inexpensive. I cannot recommend this bot enough. The bit width is unique, while the carbide tips work together to remove large amounts of wood without tons of blowouts. Stop thinking about it and grab this thing!

Used on a router slide to plan cedar for a table. I used a Dewalt DW618D 2-1/4 HP variable speed router. It worked very well. This bit cuts very smoothly. If my homemade sled was a few thousandths smaller on each side, it wouldn't need sanding. I went 2 inches through the carriage on each pass and got a 1/2 inch overlap. It cut perfectly, worked smoothly and the cutter didn't interfere at all. I don't cut more than 1/8 inch in each pass. It was the most expensive piece. But with interchangeable