🚚 High-quality 9 Pcs Truck Bed Tie Downs: Anchors & Rings for Chevy Silverdo/Sierra, Colorado/Canyon (2007-2018/2015-2018) Review

They are easy to install, I installed 6 of them in about 10 minutes. Haven't used them yet but they seem to be quite durable.

Sturdy and slim. Much better than the factory mounts, the dealer was asking twice as much for just four. Look better, stronger and longer

Very nice. Pretty easy setup, some issues were a little tricky. However; This obstacle was easily overcome with little effort. They appear to be quite durable and able to perform the function intended and I would buy them again.

Good luck finding the right wrench or socket to tighten. I ended up using my hands as much as I could and then ended up with needle nose pliers. Needless to say, they are quite difficult to install. Regardless, they are a good product. They seem very sturdy and look good.

They appear to be very well made apart from the bad threads on the locking plate. About half had bad threads that made it impossible to turn the screw by hand. I used a small wrench around the shank of the bolt to hold it while I turned the head of the bolt with the wrench. Once you get past that problem, they seem to be really good.

Everything about them is great except the price. Nine of them to plug every hole in the back of a truck for almost $100? Paying half that amount would be handy, especially when two of my friends told me that GMC and RAM included them in the purchase of their trucks. Thank you Chevy. However, they are very beautiful, strong and great looking.

Once installed they look good and feel very solid. I ordered a pack of 9. When I installed the sixth, I was disappointed to find that the plate wasn't threaded properly, so I couldn't thread a screw through it. Bad carving made it useless. Having already installed 5, I'm not taking them out to return. I don't like paying for 9 and only getting 8 that work.

Very easy and quick installation. Tighten with a wrench until nice and neat. Has helped in several truck sleeves and is holding up very well. Much cheaper alternative at twice the price. The only difference is that they stay outside and don't fold up inside the bed frame when not in use. I don't care, but if you don't want them sticking out a little when you're not using them, then they might not be for you.

Great product. Highly recommended. My pickup platform is coated on the liner and the pressure plugs are coated. I drilled through each plug and used the Drexel tool to pry each open, leaving the surrounding edge of the plug in place. The clamps will then fit perfectly. I pre-greased the threads of the bolts and tightened them with a box wrench since an open-end wrench is much more difficult in tight spaces. I would buy this product again!