🚙 AUXMART High Lift Jack Mount Rear - Perfect Fit for 2007-2017 Jeep Wrangler JK Off-Road Enthusiasts Review

This was perfect for my 2012 Jeep Jku, took literally 10 minutes to install. My bushing is 60" so there was no internal fitting. It gave my car a stern look! Costs money

Fits and will be delivered locally. I forgot it was on and went to the automatic brush washer (I'm stupid, $$). Jack and Bracket 1 washer 0. Install time 30mins max. Had to "adjust" the lower jack mounting bracket to better fit my unnamed cheap jack, but not big (I'm too cheap, $$)

Powder coating was good and the overall strength of the mount was good. However, the design or quality control department dropped the ball. My bracket didn't match my signature Hi-Lift jack. The 2 arms holding it in place should be extended a little more. My jack did not fit properly which made this bracket useless for me. If I could add photos I would.

Easy to install, seems durable. Be careful with the taillight as the door can swing far enough to hit it. But if you need a jack on the rear swinging door, you'll have to deal with that. My taillight has a metal mesh to protect it, but I see it's still possible to damage the light. But I give 5 stars for the product.

My 2019 JL Wrangler came with an oversized tire mount from the factory. This holder has a "lip" on the edge that prevents the jack holder from being flush with the frame. It required purchasing longer hardware and using shims to create a socket to get the flat surface onto the bar. It worked well and I am very happy with the installation. This is the most convenient place for a jack I've found. I also like the hood mount, but this one is better

The only thing not shown in the photos or instructions is how to install without damaging the plastic hinge covers. 1 - Remove the cover next to the hinge and slide it to the left. There is a small notch on the left end. 2 - Align the cover over the hinge and mark the center of the hole. 3 - Drill a hole larger than the insert. It doesn't have to be tight, water still runs off. 4 - Replace the covers, making sure the holes line up with the screws. 5 - The rest is easy and provided according to…

Installation is easy. Looks nice and clean on the back of a jeep. Holds the jack in place so it doesn't rattle if you also use a handle insulator. INSTALLATION TIP: The instructions state that you must remove the decorative plastic covers over the hinges. This will expose the ugly loops at the bottom. Instead, I used a hole saw and drilled holes in the plastic covers for the bolts and washers to go through, then reattached them to the jeep. Then I mounted the jack mount. It ends up looking a…

Ordered yesterday at 6pm and received today (Thursday 8/2/18) by 10am. I waited for lunch to install it and it didn't take more than five minutes. The instructions aren't well written, but you'll get the gist just by looking at the details. With the tailgate closed, remove the Jeep (2014) door hinge covers (easy to remove), remove one screw on each hinge (13mm head), insert the long screws (supplied) with washer into the holes in the jack brackets at the top and bottom , place the seal on the…