🌟 Bargman 34-76-243 Incandescent Double-Bulb Interior Light with Dual Switches: Illuminating Excellence Review

I bought this to replace the factory light in my van's bathroom. It fits perfectly with the base of the previous lamp. I paid less for this than the RV dealer's service department charged to replace the light, and I like the separate switches for each bulb. I would buy this item again.

Bought to replace lamps in an A frame trailer. Very, very easy replacement, only takes 5 minutes. I installed two bulbs at different levels so I can turn on a bright one when more light is needed and a dim one when little is needed. Works great. faster draining of the battery when they are on.

Used to replace a light bulb - the single light switch in our camper van's bathroom. I placed a white LED on one side and a red LED on the other for night time. It worked great! The quality is as good or better than the original light that was in the van so I'm very satisfied.

These headlights are a HUGE improvement over the ones we replaced on our camper! We like the easy-to-use on/off buttons more than the "slider" on/off switches. They were easy to install. Just hold the screws while you remove the old one, connect the wires and drill the screws. Just like one, two, three! I've bought four so far and plan to buy at least four more!

What a great light! When camping, I connect to the land network half the time and only to the battery in difficult conditions. I put an LED lightbulb in one lamp socket and an incandescent lightbulb in the other. At 120 volts I turn on a lightbulb because I prefer the light from that lightbulb. When the battery is low, I turn on the LED light bulb, because the LED light bulb extends the battery life considerably. Great Value! Highly recommended.

I replaced an old dome light with this light in my 1995 Ford Windstar. No problem. It's bigger than the old one, so it closes the old hole. It's a lot brighter than the old one. Also, it has separate switches for the passenger/driver's side lights. It's light, so a couple of screws in the headliner hold it in place nicely. I could just hot glue it's so easy my windstar had the dome light on the whole time so it's nice to turn the switches off now! I'm a happy buyer I recommend this lamp I…

Update: Having used my camper on a recent trip I had a chance to test these lights out fairly well. 30 minutes after the lights went out I touched one of them to see how hot it was. HOLY COW what heat from these things. Actually, I'm a little worried about her now. I actually only ran each light in single mode, not dual mode. In fact I have five of these lights and all five are as hot as the others. I can literally only keep my hand on the lens for about 20 seconds and then I have to take my…

Supplied without installation instructions. Slide the lenses about 1/4 inch towards the ends of the light and then you can remove them. You can use up to 8 screws (not included) or just two diagonally opposite screws to mount it on a solid, flat surface. The socket is NON-POLARIZED (you can connect the bulb to + voltage using any terminal you like), which doesn't matter with an incandescent bulb (supplied), but does require some care if, like me, you're replacing the bulb with a shade want with