Battery Adapter for Milwaukee M12 🔌 Dock Power Connector - 12V, 12 Gauge Robotic Review

Fits my little test board project. The M12 battery fits well, there is a top and bottom on the battery mount so make sure it goes right. Cable quality could be better

Having a 12 volt power supply is very handy. Unfortunately, the base does not allow to fully insert the battery. In order to work, the power supply had to be removed from the base.

Used for my daughter's drive wheel. I have several of these batteries and they last longer than their attention spans. This is a good alternative to buying a new Power Wheel battery.

I used it to control my electric skateboard's blue LEDs, fan and LED headlights. It worked great. I subject it to a ton of road vibration abuse. So far, so good.

I have this for my TS500 portable soldering station to run on M12 batteries. Works well, but not as ergonomically stable as I had hoped. The adapter itself works well and is fairly durable; fell on concrete several times.

Batteries are a bit difficult to insert and install but snap into place. The wires supplied aren't too big, at first I thought it was a solid wire, but it turns out it could be 7 stranded wires - very tough. The battery connections look flimsy, but it's enough for what I need. Wait and see how he holds up

It's all done right - the base slides out for easy screw base installation, the body is well made and holds the tool's batteries in place without rattling. The outgoing wire is pre-tinned and has a large diameter that withstands heavy loads well. Absolutely worth the price!

It would be nice to know that this is a 3 piece item and not a solid mount. Also, the battery I was planning to use with this item would not snap into place with the bracket installed. Do not order this item. Check out other manufacturers. Very disappointed with this purchase. Edit, I'm idiotic. The bracket was at the back. But it's nice to know that it was 2 of them.

ATTENTION! M12 batteries do not have built-in deep discharge protection. You need to control the voltage and current you get from the battery through this part. If you don't do this, you will likely over-discharge your battery, causing it to fail. This product works as advertised but fits a little tight. The wires are one piece so don't expect them to bend much. If desired, it is quite easy to swap the wires.