Ideaker Bearing Support: Horizontal Bushing Solution Review

Linear Bushings slide with more resistance than anything 3D printed. The bindings are ok but don't hold the rod well without slipping. Poor design but you get what you pay for

Just one stick was just enough for my project. The bearings made an audible grinding noise and seemed to stick constantly. 2 stars only because I will use it for something else over time and it was delivered on time.

First impressions are about the quality I expected for $35. The bars are straight for the most part, within about 0.3mm at worst. The bearing seems good although it's the first I've ever had, one was a little rough at first but running it with some oil eliminated the chatter. However, there is one big problem: the support blocks are rather poorly made. The holes for the rod are enlarged and cannot be clamped. When it's fully closed (which requires so much torque that you can break the allen…

guides that had more resistance than anything that could be printed on a 3D printer. The bindings are ok but don't hold the rod well without slipping. Poor design but you get what you pay for

Only one pole was just enough for my project. The bearings made an audible grinding noise and seemed to stick constantly. 2 stars only because I will use it for something else over time and it was delivered on time.