🛥️ Top-performance Boat Alpha Bravo OMC Gimbal Bearing Installer Puller for Precise Alignment Review

I didn't want to buy it but after changing the cardan bearing I was forced to because I couldn't align it with the engine. Save yourself 3 hours of bloody work and sweat trying to reinstall your outboard and buy this kit.

Tool does what it's supposed to do no problem please advise drilling a hole in the shaft to mark the gimbal bearing hinge on the shaft and make the width , which you can drill a straight hole with your free hand if you don't have a drill press

THIS PRODUCT COMES WITH A ROUND FEATURE FOR INSTALLATION. THE BEARING BEARING MUST BE INSTALLED. WILL NOT DO THIS. The installation block is too big, you can't lazy it. YOU MUST CHECK THE HOLE IN THE 1 INCH ROD SUPPLIED WITH THE UNIT. WHAT AN IDIOT IS THIS SET. YOU CAN SIMPLY INSTALL A REGULAR GIMBLE BEARING ADJUSTER RING. CHEAP SHIT.

- The balancer shaft does not match the cardan drive bearing. . This means it's a completely useless piece of metal rod. The removal tool works well and removes the bearing with little effort.

This is by far the best gimbal bearing removal tool! It is easy to install and effortless to use. I replaced a bearing that had been sitting in place for over 9 years and this tool removed it as if it had just been installed. The tool is very well made, all the details are precisely finished. Forget the cumbersome slide hammer. This is the only way. Michael Smith, Medina, Ohio.

I edited my answer after trying to use the bearing reinstall tool. First, there are NO instructions. I had to find instructions on competing tools to figure out how to assemble these to remove the bearing. That's where my only star comes from, she took the bearing well. But that's the only thing he did well. When it came time for a clean install I had to look elsewhere again for ideas on how to use this. The black thru-bolt ring appears to be for reinstallation, but there is no ring hole in the