🔧 High-Quality BETTERCLOUD Cylinder Gasket Piston Ring Kit Set - Perfect Replacement for Yamaha PW80 (1983-2006) Review

order arrived quickly in good packaging. Cylinder and head look quite good, the casting is a bit rough but the finish looks good. Haven't installed it yet so can't comment on performance but it should be better than worn stock parts.

junk. The piston is stuck in the cylinder, the cylinder is cracked, the head is worn, painted silver, the sealing surface is destroyed, the gaskets themselves are bent and cracked, the spark plugs are in the trash because they were not properly packaged and gap protection arrived. When shipped, all the parts were simply thrown into a box without proper packaging. Do not buy

The only complaint is that the metal gasket has been beaten. Another thanks for no modifications to the rings and no deburring of the edges that I collected with 2-stroke oil after assembly right out of the box. I needed a drill and broke it as soon as it happened and there is no carb adjustment on a brand new carb. My pw80 has much more power, this kit worked for me, I wish you all the same experience!

Haven't even put the parts on yet, as soon as I took it out of the box, I found that the cylinder was broken, the part is still usable, but this purchase is already disappointing . After installing the parts on the bike, update #1, this is ten minutes after the first check, the metal gasket that came with the kit has become unusable, it looks like a dog ate it before putting it in the box hat!, I add a photo of it

The packaging was pretty terrible. Both piston rings were bent and not the right size to properly fill the piston ring gap and are the cheapest material I have seen for piston rings. I used my old piston rings to finish the job. The metal seal was bent and had visible puncture marks. The lower cylinder's green gasket has ruptured. Piston pins were cheap and inconvenient.

The head gasket and base gasket are packed loose in the jug box and will cause damage to the gasket! Connecting rod bearing missing! Lack of basic quality control and here is the result. The quality of the jug seems ok, the head bar is a bit rough but looks like it will work. Candles are nameless and I won't use them, I'll stick with NGK. The piston looks good but feels light and a little cheap. The studs look good, the nuts are regular hardware store nuts and I'll be using the OEM ones again…