🧇 Breadboard Solderless Jumper Kit - ALLUS BB-018: 3Pc 400 Pin Prototype PCB Board + 3Pc Dupont Jumper Wires (Male-Female, Female-Female, Male-Male) for Raspberry Pi and Arduino Review

Blind rosettes stretch very easily and come loose during use. Some of them have been moved inside. However, the jumpers were great and worked well for what I needed.

You get a lot of jumpers in a good color scheme (to help you keep track of which wire goes where). The Micro Breadboards are also absolutely durable and functional. These jumpers aren't as good as the rubber "stand" varieties (they have a hard plastic stand, like PC jumpers), but for the price, that's negligible. The package will do what you need and the price is right.

Assembled from various modules with plugs or sockets, I never had the right wires. It was a nice little package to connect different devices together.

The quality is very disappointing. The pins do not fit properly on the board, force is required that can bend the pins. Some cannot even be fully inserted. Even when the pins are inserted they are not held in place and must be held at a certain angle to even make contact. Virtually useless

You get a lot of jumpers in a nice color scheme (to help you keep track of which wire goes where). The Micro Breadboards are also absolutely durable and functional. These jumpers aren't as good as the rubber "stand" varieties (they have a hard plastic stand, like PC jumpers), but for the price, that's negligible. The package will do what you need and the price is right.

Cables: The connectors on the ends of the cables are really flimsy. You have to grab the wire and sort of push the connector along with it, or the plastic will fall off. But aside from wiggling the plastic back and forth, the wires are fine. Layout: Only acceptable quality. All connections were fine but plugging in can be a little bumpy as the quality of the pen is fine. Acceptable only because I needed it cheap and fast. I would go elsewhere for something permanent.