Header banner
Revain logoHome Page
πŸ”„ optimized operation of capacity plunger welding machine logo

πŸ”„ Optimized Operation of Capacity Plunger Welding Machine Review

3

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
πŸ› οΈ Workholding, πŸ› οΈ Industrial Power & Hand Tools

View on AmazonView on Π―M

Media

(2)
img 1 attached to πŸ”„ Optimized Operation of Capacity Plunger Welding Machine
img 2 attached to πŸ”„ Optimized Operation of Capacity Plunger Welding Machine

Description of πŸ”„ Optimized Operation of Capacity Plunger Welding Machine

Side Mount hold-down toggle clamp, short bar, flanged base. Plastic cover Non-slip handle for easy, safe and comfortable operation. 227Kg 500 Lbs Holding Capacity Metal Horizontal Toggle Clamps push pull. MORE SERVICES: We promise unconditional refund. Regardless of any problems with your order, please feel free to contact us directly and we will get back to you within 24 hours. With rubber cap spindle Most suitable for quickly holding down sheet metal or circuit boards, for machine operation, welding, mould, electronic equipment assembly, etc field.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

Great for jigs: hand tools

Great product for jigs etc. Just note that the threaded end screw is thinly threaded so the rubber footed screws that fit most other barrel clamps will not fit.

Pros
  • Impressive packaging
Cons
  • for drilling

Revainrating 4 out of 5

A little rough but seems to work. Sizes Listed

A bit rough on the slide when force is applied to the plunger, but seems to work to actuate a PCB programming tool. . but with thread M8x1.25 mm. The base is about 2 1/4" wide and just over 2" long, the holes fit quarter inch screws.

Pros
  • Confident
Cons
  • Out of date

Revainrating 1 out of 5

Not worth the money

This is additional information that I did not include in my review. Plunger does not fit in mounting holes. I had to change the clamp to make it work at all. When the mounting holes are opened from 0.250 to 0.281, the piston can move almost exactly over the mounting holes. I threaded a 20" bar into the clamp and supported it 18" from the clamp on the same centerline as the mounting holes. The clamp throws the bar out of the way about 3/4" and engages the clamp. I recommend to spend a few euros…

Pros
  • Free for educational purposes
Cons
  • Not sure