Header banner
Revain logoHome Page
case fan aerocool ds fan 14cm logo

Case fan AeroCool DS Fan 14cm Review

6

·

Poor

Revainrating 3 out of 5  
Rating 
3.0
Computers, 💻 Computer Components, 🧰 Computer Internal Components, 💻 Computer Components

View on AmazonView on ЯM

Media

(10)
img 1 attached to Case fan AeroCool DS Fan 14cm
img 2 attached to Case fan AeroCool DS Fan 14cm
img 3 attached to Case fan AeroCool DS Fan 14cm
img 4 attached to Case fan AeroCool DS Fan 14cm

Description of Case fan AeroCool DS Fan 14cm

type: fan, purpose: for housing, fan diameter: 140, maximum noise level: 14.20 dB, connector type: 3-pin, bearing type: hydrodynamic, maximum rotation speed: 1000 rpm

Reviews

Global ratings 6
  • 5
    1
  • 4
    2
  • 3
    0
  • 2
    2
  • 1
    1

Type of review

Revainrating 2 out of 5

Think twice before buying this product.

The first impression of using this series of fans turned out to be misleading. Yes, the fan looks unusual and beautiful. Yes, for its modest speed it has a noticeably higher airflow. However, after a few months, his vaunted bearing and heavy weight begin to play a cruel joke. Despite the declared +100500 hours of perfect operation, after half a year it starts to emit a low-frequency hum or even crackle (depending on how unlucky you are). At the same time, due to the large weight of the entire…

Pros
  • - Unusual appearance - Excellent airflow - Noiselessness (in the first months) - All necessary fittings included - Moderate backlight brightness
Cons
  • - High percentage of defective bearings - Extremely short term "perfect service" - . moderate illumination

Revainrating 2 out of 5

Purchase failed, very dissatisfied.

I wanted to install it on the side wall of the case, on the blower, and get a beautiful backlight from the outside, but alas, it shines where it blows. Turned it on, checked it: standing on the table, it is quiet, as soon as it was attached to the attachment point, it immediately rustled, now it is the noisiest in the system :( I do not advise spending money, either take the cheapest UG, or add a little and buy something with magnetic centering.

Pros
  • Backlight (shines in the direction the cooler is blowing), Quiet (when working on the table)
Cons
  • Noisy for blowing, backlight The backlight pattern is visible only inside the case (in my case), an unreasonably high price.

Its pros: I was looking for an analogue of the Noctua NF-A14 ULN, and I found this cooler is very quiet, the bundle is rich like that of the Noctua, and it costs half as much. + backlight Some cons: It smells like rubber when you open it out of the box, but who cares? Only the cooler itself smells, it does not create a smell of rubber in the team

Revainrating 4 out of 5

I recommend to buy, the product is of high quality.

For me, the above disadvantage is not critical, since the speed of case coolers is manually controlled by the controller. At maximum speed, you can still hear it, but it depends where it is installed. If on the side wall of the case, then it is quite justified that the air flow will "rustle" through the "honeycomb". If it is installed for blowing on the front wall of the case without any special obstacles to the air flow, then you may not hear any rustling. However, such a backlit cooler looks…

Pros
  • Good assembly. Looks solid. Includes silicone screws and rubberized braided power adapter. Sufficiently long power cable. There are rubber "silencers" of vibrations on the seats. Volumetric airflow. Backlight. Very quiet at medium and low speeds. The centering of the cooler does not cause visual complaints.
Cons
  • Two-pin power supply - not suitable for Fan with automatic speed control. Service impossibility.

I put it on blowing into the front of the case, the silence is complete (just believe me). But the backlight is visible only in pitch darkness! Before that, there was an old "Carlson" from Amazon, so you could read a book from its red light. In general, the backlight is a complete sadness . Pros below: SILENCE! Excellent quality of MATERIALS and assembly, the manufacturer did not stint. Interesting and thoughtful design of the blades. The presence of silicone and metal fasteners in the kit, an…