🔥 3-PACK - DADO Zero Clearance Insert Compatible with Delta 36-725, 36-725T2, 36-5152, 36-5000, 36-5000T2 Table Saws Review

They're a bit pricey but I didn't have a pattern for my table saw so it was worth it. And after a little light sanding they sit nice and neat. They do what they are made for.

Works as it should. The curves need a bit of sanding to fit the hole. The tolerances are wide so I don't have to adjust the alignment screws when switching between slotting and fine kerf.

Perfect fit for the blade. I've made a few myself that have been less than successful. It's actually better than the stock part because it's thicker and adds more rigidity. Highly recommended for anyone using the Delta Table Saw models listed.

Great Product. This is perfect for my Delta 36-725 table saw! I've crafted my own backlash free inserts in the past, but they are well worth the effort to craft. The bottom is cut perfectly to fit everything in the saw. The instructions are very simple for those who have never used a zero gap insert. I definitely recommend these zero gap stakes!

They fit my Delta 36-725 perfectly. I love my saw but hate the insert it came with. The Delta replacement was no better and very expensive! With his insoles, Robert has the perfect solution to my problems. So far I've corrected the insert for a 1/4" dual blade configuration and my thin kerf Diablo blade. 1/4 inch plywood is usually the worst when it comes to cutting it. No chips or torn edges with this insert! Just a clean cut! Thank you and keep doing sawdust!