Cllena Charger Voltmeter Multi Functions Vehicles Review

Wires and connectors are cheap and I had to redo some of the wiring but overall I am happy with my purchase. Good bang for the buck.

Easy to fix but all 8 units are powered by 16 gauge wire and each switch has a 16 ga 15 amp fused output. Cut off the input channels and add a few more and you'll be fine.

I really liked this switch box. Supervisor switches and fuses save time. The 12 volt outlet and USB charger are a plus and I like the volt meter. I installed it on my 15ft Jon boat.

I like it. Two USB ports and a classic 12 volt lighter for a small air pump. Waterproof fuses and sensors are ideal. The digital voltage protection emerged as the winner. Everyone loves to light up a number. laugh out loud.

Supplied with separate fuses/holders for each switch. And a separate main switch with fuse/holder for the entire panel that will cut off every 12V plug, lights, USB sockets, voltmeter, you get it all and easy to install.

Well the best you can do is just strip the wiring from the back and run your own wiring. It comes pre-wired but only has 1 14ga 12v and 1 14ga ground for each switch. And they were launched one by one, and not every one of them could be burned. I trimmed everything where everything could have melted in front of the derailleur on the boat I was remodeling and it works great. Haven't had a single problem with him yet and he's been in the water every day this summer. Just hope everything works the

Very happy with the product Seems very nice Nice to have a power and a negative lead and then you can both connect line to one switch for easy installation . I just got a light on my trailer. And a water pump. It comes with an extra switch in case something breaks. But very satisfied, I look very sharp. A sticker you can really put on to identify each light. I wish they had a bit more stickers with better names but that's ok I'm very happy with it.

I needed something for my battery powered golf cart that would control my accessories and charge my phone/tablet when needed. Be sure to read the specifications. The switches are not designed for high power/high current applications such as motors and compressors. You need high power automotive relays if you want to drive a high power amplifier. It's okay - the switches are easy to connect to the relay. You *must* understand wiring. You'll need basic wiring tools like a wire stripper, crimping…