Pros
- 1. Upholstery - fabric (AeroSuede, similar to microfiber), high-quality, tactilely very pleasant. It is clear that the coating is non-slip, it is pleasant to sit, comfortable, nothing sweats. I wanted the fabric. Whoever says anything about the practicality of the skin, and the operation of a computer chair made of leatherette sooner or later ends with a fabric lining under the . Leatherette - only on the sidewalls, where abrasion is possible over time. In general, wear resistance will be tested by time and operation. Appearance - 5 points. 2. The filler is not soft and not hard - just right. 3. The backrest leans back 180 degrees and the chair unfolds almost horizontally, you can take a nap. 4. Adjustable armrests made of soft, finger-wrinkled plastic. 5. The set includes a headrest and a lumbar support pillow. 6. Sitting is generally comfortable and this is the main thing.
Cons
- Moderate your expectations when buying this chair. It may look beautiful, but, in fact, this is a budget solution, and it is full of compromises. You need to be ready for this. 1. Cross - plastic. Do not believe the description on the manufacturer's website about the metal in the base. It's plastic. Mive, hard, with stiffeners, but plastic. 2. The rollers are plastic, not polyurethane or nylon, as it is written on the official website of the manufacturer. The laminate will wear out. 3. The gas lift does not look like the photo from the official site. I can’t say if this is the 4th cl, I have to rely on the manufacturer’s statements that it is the 4th cl that is used, but judging by clauses 2 and 3, the chair comes to 2022 in a different configuration than indicated in the specifications on the official website manufacturer. 4. The armrests and the erfly mechanism are attached separately to the plywood bottom of the seat. This is bad and alarming constructive unreliability. It is not known whether such a mount will loosen over time. In good chairs, the fastening of the erfly mechanism and the fastening of the armrests are a single metal plate. 5. The fastening of the “erfly” mechanism under the seat is shifted closer to the rear backrest so that when the chair is unfolded to a horizontal position, the entire structure does not tip over. As a result, we have that it is inconvenient to use the rocking function in a sitting position, since the movement of the mechanism is very hard, adjusting the spring under the seat does not help. Consider that there is no swing mode. 6. A consequence of paragraph 5 is another drawback in the design of the chair: if you sit on the front edge of the chair, it will tip forward. The center of gravity is shifted closer to the back of the chair. 7. Low. When setting the gas lift and armrests in the maximum upper position, the distance from the floor level to the upper plane of the armrests is 747mm. 3 cm missing from standard tabletop height (750mm). 8. A crooked sching comes across (see photo).
