Cutting Made Easy: OriGlam Thread Cutting Stainless Metric – Unbeatable Deal! Review

When purchasing it, some reviewers mentioned that it was small and cumbersome to use. The size is comparable to my Starrett thread gauge. Found that all metric threads are on one side of the gauge and SAE on the other side. I checked a couple of pressure gauges, they seem to be accurate. It's a Chinese-made product, but nowadays it's not. I would advise lubricating with a light oil to prevent rusting but I would recommend it at this price point.

Good. It has many sizes, SAE and metric. The tool is a bit small and it's all packed in a small package. It would be much better if they made it longer and thicker. But it seems that all thread sizes exist. Tip: Use the taps that come with your die set to find the correct thread size. One of these will fit, or you're just not the right size. Therefore, you need this tool to determine the right faucet that you need to buy.

"Made in Germany" on the product, "Made in China" on the packaging. When checking the product, one of the calibers was not stamped with a thread pitch. You can figure out where it sits between the other two sensors, but there's no quality control. It is difficult to read the level because the embossing is flat and small. It was sold as SS, I hope that's right because if the resin is corroded it will be impossible to read. I don't think it was made in Germany.