🔧 3018-SE V2 Desktop CNC Router Machine with Clear Enclosure, 3-Axis Engraving Milling for Wood, Acrylic, Plastics, Metal, Resin Carving, Arts & Crafts, DIY Design Review

I'm pretty sure it came packaged without a couple of bags of parts. In particular, I'm missing the fourteen (14) screws required for assembly, as well as the USB drive, USB cable, and brush. Ignore the last picture in the product description. It shows a pack of 10 engraving bits, but they aren't there either; I only mention them in their own sentence because looking back at the product list they are no longer in the contents part of the box, just in the picture. The sliding blocks (referred to…

Bought to do some initial wood carving (simple shapes/letter boards/small cut outs) and had nothing but problems. The design software they offer works well but has very limited features. However, the real problem lies in the (open source) Candle software and getting the project up and running without any problems. As a result of numerous attempts, the software gives an error in the middle of the project and there is no way to continue the cut from the last point where the error occurred, so you

I bought one of these and when it appeared on the platform it was hanging out. I notified Foxalien about Revain and was able to exchange the broken device for another device. When he arrived, his portal was also weakened. I contacted the previously helpful service department but never received a response from them. So much for support. I was able to loosen the screws so I could move the Z-rails just enough that the spindle couldn't move. I don't know if that's good enough. I haven't cut…