🔴 Dremel 516 Bullet Abrasive Point Review

Basically a very small Scotchbrite wheel. Good for deburring aluminum but lifespan is limited. I would like to find a cheaper option.

Purchased to deburr sharp edges on aluminium. It's too soft. Grooves have formed on the sides causing abrasion where I didn't want it. It may be ok for other applications, but not for this one.

Very good for sanding aluminum in hard-to-reach places without leaving heavy scratches. Roughly equivalent to 600 grit. Works very well to get into tight corners to remove material such as light pouring/pitting. Used it to sand the intake manifold in all nooks and crannies for polishing. Just be very careful not to carry the tip inwards all the way to the shaft. The inner end of the bar is very sharp, so wearing down to the bar is like hitting the piece with a dremel nail. You need to round the