🏰 Ekena Millwork CM12BR Bradford Ceiling Medallion, 12.5-inch Outer Diameter x 3.875-inch Inner Diameter x 0.75-inch Projection (Fits Canopies up to 6.625 inches), Primed Review

They are really easy to install and add style to our dining room. I am very satisfied with the product and will definitely buy it again.

I replaced the hall light with a pendant light and it was a little smaller than the previous hole. This worked well to hide sharp corners. At first I didn't want to use glue to be perfectly centered and used command strips instead. The command strips were meant to be temporary but I just left them on forever as they work fine!

Elena Milvork picked the winner. It's 3D NOT flimsy plastic so it holds its shape well and you have to work hard to break it. Sticks firmly to the ceiling at the back; Front details are made in 3D and clearly visible even without painting. I used 2 different size canopies on the fans; both housed. We can cut with an X-Acto knife if you want your fan shroud to fit inside the inner circle (you can also just center the shroud - that looks nice too). Really good product at a great price.

Sturdy than I expected and perfect for my application. I'm so glad I decided to check on Revane before looking elsewhere for the locket. I glued it to the ceiling with general purpose sealant and taped it in place for about 15 minutes and then added a thin layer of sealant around the edge so there was no gap. I also applied a quick coat of the same ceiling paint I used in the room and it blends in perfectly (although it's going light at the time. My paint toned it down a bit). I would recommend

Excellent product. It comes unfinished so you can finish it to match your light fixture. This is ideal for converting recessed lights to pendant lights and covering the hole. I think if you don't finish it it will look boring. I mixed 4 parts black acrylic with 1 part bronze glitter acrylic and then brushed the edges with a very small amount of bronze. In total I spent about half an hour drawing 3 of them. It matched my light very well and hides the previous recessed light holes that I…

I want more! However, I still love it. I only used it in a small room. It has a flat back so I was able to glue it to the ceiling with liquid nails. This is plaster, so it looks like wood. Hard plastic stamps look terrible because it's obvious what they are. To be honest it looked fine just primed but I went ahead and spray painted it satin white. Very good value for this locket. It is ideal for fixtures 17 inches or less in diameter. Don't buy it for more light, it will look stupid. To be…

We ordered it a few months ago but haven't installed it yet. We thought it would be a lot harder to remove our outdoor ceiling fan to install the new ceiling medallion so we kept putting it off but it turned out to be a lot easier than expected and now we don't know why we didn't to have . Before. The old locket was plastic and as old as the house, which showed its age clearly. This was a big improvement and no longer draws your attention negatively. It is slightly larger than the locket we…

We put this locket on our new lamp last week and I love it! We looked for the locket at Home Depot and Menards and could only find cheap plastic ones, so I was glad it was thick and good quality - even at the same price as the plastic ones in stores! We have popcorn toppers (unfortunately, but they'll come back eventually, right?) so I wasn't sure what that would look like and was hoping we didn't have to tape it since the popcorn toppers from back then would fall off. Luckily no gluing was…