🖨️ ELEGOO UV Curing Standard Photopolymer Printing Additive Manufacturing Products: Enhanced Printing Solutions Review

Worked very well. This is my very first print on my Elegoo Mars printer and it stuck to the canvas well. It has an odor reminiscent of playdough but stronger. Sending doesn't bother me and since it's my first time using this type of product I have nothing to compare how strong the pairs are. It was very easy to use. Upload the printable file, fill in the resin, click print and in 3 hours I had my prints. It can get messy so gloves and lots of paper towels were used. I wasn't sure how fragile…

I am a jeweler who has dreamed of 3D printing for a very long time. I finally took the plunge and bought a longer Orange 10. I've been measuring my first pressure every day for about a week. I can't see any shrinkage. I made the bezel 0.4mm and it's still 0.4mm. So for people worried about shrinkage I would say don't do it. I wish I could say the same about injectable wax! This material cleans very well. I broke a corner on one of my prints trying to remove the support after the piece had…

To be honest this is the only resin I've used. will use their brand to be sure. Since then I have continued to buy this particular resin. The choice of colors is great, so far I've used grey, white, black and bright red and they all turned out great. I've had very few bad runs on my prints and they may not have been resin related. The reasons I only bought this resin are as follows, the faint smell is barely noticeable to me, 90% IPA actually smells MUCH more noticeable than resin and as I use…