🌡️ EVGA mITX 92mm Sleeve ACX CPU Cooler 100-FS-C901-KR for Intel Socket 1150/1155/1156 - Direct Touch 4 Heat Pipe Review

By far the WORST cooler I have ever used. I've been building PCs for over 15 years and have probably built over 300 (I do this for friends/family and as a side hustle). There must be a way to rate ZERO stars. Attachment sucks. All of the clips were hard to keep, and one won't stick at all, no matter what. Over the years I've bought a lot of EVGA hardware, GPUs, power supplies, and all-in-ones. Usually very good stuff, it's a complete fail! I saw some reviews but they were discounted for $10…

This cooler replaced the stock Intel cooler on my i5 10400F on my Asrock B460m ITX motherboard. The maximum temperature during a multi-core run of Cinebench R23 is 58 C. The temperature of the standard Intel cooler reaches 100°C. With Thermal Grizzly Kryonaut thermal compound. The 42 degree drop in peak temperature is amazing! This cooler fits perfectly in the Corsair 250D ITX case. The mounting solution is identical to the stock Intel cooler, making installation easier, but the clips are still

Update: This thing has decided to leak under load. Prime95 for about ten minutes, then I see coolant splatter on the inside of my case window right next to this fan. I take it all apart and find that the inside of the fan is heavily spattered with oil/grease/antifreeze like clear goo. Double your tee shot. Like others, I had serious problems with the latches that attach the cooler to the board. The problem in my case was that 3 out of 4 pins were broken. When you push the pins down, two more…

Terrible mounting clips. I returned the first one because after unboxing one of the pins was loose and wouldn't snap, the replacement wasn't much better. I was able to lock (I use the term "lock" very loosely) but one of them wouldn't lock no matter how I pressed or twisted the pin. motherboard. Although the clips on this cooler felt worn, both when originally ordering and when ordering a replacement. I ended up installing the stock Intel cooler and don't know what to do now should I go back…

I bought this 92mm EVGA mITX cooler to fit an EVGA Hadron Air Mini-ITX case on an EVGA Z97 Stinger LGA 1150 Mini-ITX motherboard. I thought by buying all EVGA components I could be sure of compatibility, but I was wrong. I wasn't able to screw the four legs of all these coolers to the LGA 1150 socket of a Z97 ITX motherboard. As other reviewers have reported, the four plastic mounting pins do not work properly. I ended up securing only 3 of the 4 corners after making several attempts to…