Header banner
Revain logoHome Page
๐Ÿ”Œ replacement ezgo 50 amp dc fuse for 36 volt powerwise charger - part # 28106g01 logo

๐Ÿ”Œ Replacement EZGO 50 Amp DC Fuse for 36 Volt Powerwise Charger - Part # 28106G01 Review

3

ยท

Very good

Revainrating 4.5 out of 5ย ย 
Ratingย 
4.5
๐ŸŒ๏ธโ€โ™‚๏ธ Golf, ๐Ÿฅ‹ Sports & Fitness

View on AmazonView on ะฏM

Media

(1)
img 1 attached to ๐Ÿ”Œ Replacement EZGO 50 Amp DC Fuse for 36 Volt Powerwise Charger - Part # 28106G01

Description of ๐Ÿ”Œ Replacement EZGO 50 Amp DC Fuse for 36 Volt Powerwise Charger - Part # 28106G01

The 50 Amp DC Fuse is used on Jacobsen and E-Z-GO Powerwise & Powerwise Total Charge III & IV Chargers. This fuse was used on EZGO Electric TXT & Medalist Carts years 1994-2008 & 36 Volt MPT/WH Vehicle years 2003-Current. This fuse usually blows in PowerWise chargers due to the failure of one or both of the chargers rectifier diodes. The fuse used to protect the charger components when a diode fails. Replaces Part #28106G01, 28106-G01.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Efficient Power Charger for My Golf Cart

I recently purchased a power charger for my golf cart in Sports and Outdoors store. My analysis of this product showed that it is perfect for my needs. The charging rate is faster than my previous one, and it works well even when my cart is fully discharged. The compact design makes it easy to store and take with me when I travel. The only con is that it can be a bit expensive for some buyers, but the quality is worth it.

Pros
  • Fast charging rate, compact design
Cons
  • Higher price point

Revainrating 5 out of 5

charger fuse! Not for a car!

Unfortunately bad. Wrong part! ๐ŸŒŸ๐ŸŒŸ๐ŸŒŸ๐ŸŒŸ๐ŸŒŸFive stars because the item is perfect and arrived on time. Make sure you want this for your charger. Because I accidentally ordered, thinking it was the trolley charge port fuse.

Pros
  • Easy to read control panel
Cons
  • Updates available

Revainrating 3 out of 5

good and bad

The fuse works and corresponds to the description. However, in almost all cases you have to bend the end slightly when installing it in the charger. Some of these fuses have a slightly flexible jacket. It's not like this. Therefore the jacket may pop out when you try to install it. Seems to be a design flaw in the charger itself, but again these fuses are sold for this application. You have a chance of solving this problem if you tightly wrap the end with electrical tape before gently bendingโ€ฆ

Pros
  • Few competitors
Cons
  • Tape