🔧 Enhanced Fabtech FTT10002BK Angled Spare Tire Mount Kit (Angled Mount Only) Review

Great tire holder. even better value. Supplied with all necessary equipment. I installed the rivets into the bed and secured them with the screws provided!

Installation was successful. PLEASE NOTE: In my box, it was hard to tell there was an extra layer inside the box. It wasn't obvious where the main mount was hiding. Longer screws may be required for installation; for your information.

Excellent quality. I installed this spare wheel holder on a vehicle that is used frequently for commercial purposes. I recommend this product to anyone who needs a durable and lightweight spare wheel holder. It looks good and there's room for a jack and tools in the back of my truck.

Works well. The screws that came with it worked perfectly. It also comes with nylock nuts so no lock washers are needed. Drilling through the bed eliminates the need for longer screws. Of course, this depends on where you want to place it in the end. For the installation I used 14/15mm sockets and wrenches. There is a hole near the bottom of the rod holder clamp that you can thread a padlock through, which is great.

Finally an inexpensive mount for my application. I've seen others much more expensive and probably a lot more "muscled," but I don't drive my Jeep off-road very often, and it's not my daily driver. (Also, the mount is hidden, so don't buy a prettier one if you expect to see it.) So I guess I can do without this light/medium mount. Installation was pretty easy. The only change I had to make was that my replacement part was very "deep" and I had to go to my major hardware store to get a 4 inch…