📊 Faria 3003.3445 Tachometer - 7000 Coral Review

Faria makes great products and this mark is no different! Easy to install and when you need it the tech support is amazing!

I like the sensor, but the installation doesn't work, the console is too thick, I may need to get creative with the hardware, or I have about 300 sensors that I can't use!

I used these total stations on my '79 Silverton. They work great. They fit snugly in the original holes and are very similar to the originals.

Used to replace a tachometer on a 1989 Fourwinns Freedom 170. IB/OB 2.3L OMC 4 cylinder Cobra engine. Same size as original. Only 3 out of 4 wires used. Set the rear derailleur to position 1. Works great, looks good.

Used to replace my 30 year old tracker sensor on my 1989 Tracker 1600TF. Landing was the same, climbed straight into the factory hole without any changes. Easy to connect and assemble for a clean look.

Very happy with this unit. If you compare it to a digital touch, then he's right. Beautiful appearance and easy installation. While the instructions for setting up the device could be a bit better, with just four options, it's easy to find your way around.

Bought this tachometer to replace an old Teleflex that stopped working. Installation would have been easy enough, but the hole cut was too small for the faria. The pole switch setting was confusing for me and I contacted support and Jason with Faria called me back a few minutes later and gave me a solution. The stroke worked flawlessly up to 5200 rpm, just like silk, and the arrow doesn't jump, it sways gently. However, it shuts off when the RPM goes above 5200 and will not function again until