Upgrade Your Dashboard With HOTSYSTEM Universal 2Inches 52Mm Dual Hole A-Pillar Gauge Meter Mount For Car Auto Review

I got this for a '13 Dodge Charger and it isn't universal enough to work, I don't care how much trimming or fitting you do. The curvature of this plastic piece won't mate with the A pillar. The only other car I had to test on was a '95 Volvo, for which it did not work either.Otherwise it seems decent enough. The gauge fits into it nice and tight.

Would not even come close to fitting any car or truck I tried wanted to return it but I have to pay 5.99 to send it back don’t waste your time buy a better unit

I have 3 cars. In NONE of the 3 it fits.In addition, it is plastic of very poor quality and very poor finish.I will send it back.

This is a universal fit fit as it states. It requires work to install as it is not made for direct applications. Works very well but order specific if you want direct fit.

Overall the quality is acceptable. The finish was good. Wish it fit. If it did, I would use it. Heat gun option would not work because the shape was "off" by too much.

Didn't work with the gauges- no way to put collar on backside of gauge to secure it. Returned with both gauges that were supposed to fit this.

The bezel seems to be made of strong plastic with a nice even finish. It is a little wider than the pillar in my 85 C10 but it could be trimmed to fit. I actually picked up a turbo so I'll be getting the same bezel for dual gauges so I can run a boost gauge.

This is really easy to install. Use a heat gun if you need it to fit your pillar. Also buy a holesaw to open the rear to put your wire through for your gauges.

First It didn’t fit my truck so it is not universal, even if I could try to make it fit, it didn’t come with any hardware Or instructions to install, like it says it comes with. When I tried to return it, it was going to cost me more money than just to keep it.

After I recieved this product, I went to my car and tried it, but this one is to big and I coud'nt install. it says universal but its not.

This is going back for a refund as it had a couple of problems. The first is it wouldn’t snap over the cars A pillar like it should have. The car has an air bag in the a pillar and I didn’t want to use any tape or screw to holdIt in.The second problem is the gauge I had was a 52mm and it had a retaining ring that screwed on the back of it, the way this was built the only way to get that retaining ring in place was if the gauge stuck out 3/4’s of an inch. Save your money.

Just what I needed and feels like it's made out of good quality plastic. shipping was fast. Be aware just beacuase it says universal doesn't mean it will fit anything and everything. Look at the shape of the plastic and use your own judgement.