Metallic Chocolate Filament Printing Materials Review

Prints well if you're lucky. I got it because it was my first silky metallic yarn and I was familiar with printing. But it really shouldn't be rising in areas where it shouldn't be. Or crumble like a castle made of dried sand. My advice to anyone thinking of metal pla. But somewhere else. There are far more failures than successes. Even if you do absolutely everything you write. Sometimes it's just a bad thread. Even if you store it in a dry box. keep it clean And even make sure the silica gel…

As others have said this is not a silver tone at all so don't be fooled by the image on the product page. More copper or metallic coffee color. I knew this before I ordered and I'm happy with the color. I used it to print Flash Gordon's rocket and it turned out pretty well. As I've found with many metallic or silk threads, you need to use an extra outer wall or the fill pattern may show through. There is a small amount of it on my rocket but nothing to complain about. The overhangs are decently

Looks better than I thought! VERY good thread. Beautiful and high quality rolled up! Printed on nozzle 205 bed 60. Update: the start of each print goes very well with excellent adhesion. After that, however, everything goes wrong. I haven't been able to finish the print without clogging yet. I've tried the same part about 6 times and it clogs EVERY TIME! This is very frustrating. It gets to the point where I have to be seated at my printer so I can spot the blockage right away or it gets messed