Freud 85 300 10 Degree 1 Inch Height Review

This router bit was a complete letdown. Based on our own experience, we found it to be extremely dull and ineffective for any industrial and scientific purposes. The only positive was that it did fit in our router. However, the cons outweigh the pros with this one. We had to apply an excessive amount of pressure to get any sort of cut, and even then, the results were lackluster. Save your money and invest in a higher quality router bit.

Works as advertised. There is nothing more to say if something lives up to expectations. It came quickly, had ordered from this seller before and will do so again.

Part of my cabinet door and drawer slides require a slight angle. This beat is high quality and impeccable. I worked with maple and closed the gaps by removing the material with four progressively larger cuts. You can adjust the final cutting angle by adjusting the router table; My ending angle had to be 8 degrees, so I used a 2 degree stop angle to bring my ending angle to 8 degrees in my project (10 degree tool angle minus 2 degree stop angle).